Manicure with volume branches

We continue to acquaint you with the 3d sliders of the autumn theme. Today, the hero of our review will be a slider with bulky sprigs 3d143

To perform this manicure, we need:

• Base and top for gel polish;
• Color gel polish;
• Slider design;
• Water;
• Scissors;
• Paper napkin;
• Tweezers;
• Silicone brush;
• Gel polish lamp;
• Liquid to remove the sticky layer.

To begin, prepare the nail plate for applying gel polish, apply the base and color coating. The color can be any, since the 3D sliders are suitable for working with any shades.

Today we have a BPW 3D slider design (number 3d-143).

In order to apply this type of design, do the following:

1. Cut out a piece of design you like and drop it into water for a few seconds.
2. Apply a thin layer of base on the color coating.
3. We take the slider out of the water and promakimivaem through a paper napkin.
4. Put the slider on the undrawn base.
5. Using a silicone brush we smooth the slider.
6. We place the hand in the lamp for 1 minute.
7. Take the top and squeeze the brush well. Apply the top with a thin layer, with trailing movements. Particular attention is paid to the boundaries of the film, it must be well sealed.
8. Make sure that a large amount of material does not fall on the nail plate and does not smooth out the relief.
9. Dry and remove the sticky layer.

We got such an unusual and rather simple manicure with a volumetric design.